Winsta Maxi Softwire System

Cableaway WINSTA MAXI

WINSTA® MAXI - For a higher performance

The WINSTA® MAXI connector is designed as 5-pole power supply connector with a maximum conductor cross section of 6 mm2and rated current of 32A. It has been designed to be used in conjunction with WINSTA distribution boxes. Furthermore, it can also be used to minimize the drop voltage over longer cable runs.

Product profile

WINSTA® MAXI connectors, Series 831
•The power required for upstream loads benefits from a 7A higher supply current, when compared to the currently available WINSTA® MIDI series.
•No additional fuse protection is required, even though the cross section is reduced from 6 mm2 (WINSTA® MAXI) to 4 mm2 (WINSTA® MIDI), when the output cables are less than 3 meters in length.
•WINSTA® MIDI and WINSTA® MAXI cannot be mated together, due to the inherent safety of their unique coding design.
•Time and cost saving CAGE CLAMP®S technology for push-in connection of stripped solid wires and ferruled stranded wires.
•100 % protection against mismating.
•Number of poles: 5 poles
•Wire range: 5 x 0.5 mm2 - 6 mm2
•Rated voltage: 400 V/6 kV/3
•Rated current: 32A

Preparation

1.Sheath removal length = 80 mm
2.Stripping length = 13 mm
3.Advance PE conductor = 10 mm

For the connection of flexible conductors, manipulate clamp spring using screwdriver (blade width 5.5mm) and insert the stripped conductor to the stop.

Strain relief mounting

Unscrew strain relief from the lower part of the housing . . .

. . . and latch wired plug-in connector onto the lower part.

tighten strain relief with screwdriver.

Wired plug-in connector in the lower part of the strain relief housing

Latch on upper part of strain relief housing

Marking

The printed marking of the plug-in connector is clearly visible in the opening of the strain relief housing.

Complete and plug together